

PolyMaker PolyDissove™ S1 water soluble filament 1,75mm 750g
PolyDissolve™ is a family of soluble carrier filaments. This family offers a support solution for our portfolio of filaments. It allows greater freedom of design.
PolyDissolve™ S1 is a water soluble carrier for PLA, TPU, PVB and Nylon based filaments from our portfolio. It has been specially developed to have a perfect interface with these materials while maintaining good solubility.
Diameter: 1,75mm
Quantity: 750g
PRINT SETTINGS
Temperature of the nozzle: 215˚C - 225˚C
Print speed: 20mm/s - 40mm/s - 40mm/s
Bed temperature: 25˚C - 60˚C
Bed surface: glass with adhesive, blue ribbon
Cooling fan: ON
Based on 0.4 mm nozzle and Simplify 3D v.3.1. Printing conditions may vary depending on printer and nozzle diameter.
MATERIAL COMPATIBILITY
PLA-based material from the Polymaker portfolio + +
PETG-based material from the Polymaker portfolio +
ABS-based material from Polymaker's portfolio - -
PC-based material from Polymaker's portfolio -
PVB-based material from the Polymaker portfolio + +
TPU-based material from the Polymaker portfolio + +
Nylon-based material from the Polymaker portfolio + +
+ + support the model very well.
+ usually support the model depending on its geometry.
- usually does not support the model, depending on its geometry.
- - the model does not support.
NOTES
Drying settings: 80˚C für 12h
Other:
It is strongly recommended to use the address PolyBox™ when printing with PolyDissolve™ S1 and keep it in the resealable bag.
Download Technical Datasheet
Download Safety Datasheet